Ds-80249 -p Rev 1.2 Firmware 【Recent - SOLUTION】

Hex Command: 0x5A 0x10 0x00 0x01 Expected Response: 0xA5 0x10 0x01 0x02 (where 0x02 indicates Rev 1.2)

Mitigation of signal noise or impedance mismatches found in earlier production runs. ds-80249 -p rev 1.2 firmware

What is this board inside (e.g., Dell, Supermicro, HP)? Are you currently seeing a specific error code ? What operating system are you using to perform the update? Hex Command: 0x5A 0x10 0x00 0x01 Expected Response:

The fluorescent lights of the server room hummed a low, lonely C-sharp as Elias pried the metal casing off the unit. The label on the back was faded, but the silkscreen on the PCB was clear: . What operating system are you using to perform the update

Check your PC's Device Manager. If a yellow exclamation mark appears next to your programmer, reinstall or update the USB drivers.

: Checking for updates is highly recommended to protect against known vulnerabilities like CVE-2021-36260 , which affected many older Hikvision boards. Community Insights Discussion threads on platforms like Reddit's Hikvision Community