Harvey Hv3 Water Softener Installation Manual

Load two blocks of Harvey block salt into the front compartment.

: It should be placed on a firm, level surface, ideally close to the rising main stopcock to ensure the whole house receives softened water. Plumbing Fittings Bypass Set

The control valve is the brain of the Harvey HV3 water softener, and programming it is an essential step in the installation process. Here's a step-by-step guide to programming the control valve: harvey hv3 water softener installation manual

Since Harvey no longer actively sells the HV3 (replaced by HV2 and HV4 in many markets), try these sources:

The Harvey HV3 is a non-electric unit that relies on water flow to trigger regeneration cycles. However, you can also trigger a manual regeneration when needed. Load two blocks of Harvey block salt into

The salt blocks sit in approximately 1cm of water in the salt chamber, dissolving slowly from the bottom. Once a block drops to about a third of its original size, another block can be placed on top.

Locate your rising main (the main cold water pipe entering your house). Here's a step-by-step guide to programming the control

Hand-tighten the nuts, then give them an extra quarter-turn with a wrench. Do not over-tighten, as this can split the rubber washers. Step 5: Route the Drain and Overflow Lines